Filling Solution Tank - Tennant 5540 Manual Del Operador

3. Unfasten black latch at front of machine and hinge
open skirt housing to access motor hub (Figure 8).
4. Select recommended pad or brush that best
meets your cleaning needs.
NOTE: Consult your authorized distributor for pad and
brush recommendations.
5. (For Pad Installation) Attach pads to pad drivers
before connecting drivers to motor hub. To attach
pad to driver, remove plastic centerlock ring from
pad driver. Position pad on pad driver and replace
centerlock ring (Figure 9).
6. Attach brush/pad drivers to motor hubs. Align (3)
mounting studs with slots in motor hub. Give driver
a quick turn toward spring clip located on motor
hub. Be certain pad driver is securely fastened
and spring clip locks into one of the studs before
operating machine (Figure 10).
Tennant 5540/5560 (08- -05)
FIG. 8
FIG. 9
FIG. 10
Home Find... Go To..
NOTE: Always make sure pad driver and motor hub
surfaces are clean before installing drivers. Keeping
surfaces clean will make it easier when removing pad
drivers.
7. Close skirt housing and refasten latch.

FILLING SOLUTION TANK

1. Transport machine to filling station. Raise
squeegee and brush when transporting.
2. Turn off machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
3. Shut off solution flow. Pull solution flow lever
completely back to shut off (Figure 11).
4. Open solution fill door at front of machine and fill
solution tank with clean water, 60°C (140°F)
maximum temperature. Or you can fill solution
tank using hose fill port at rear of machine. Pull off
plug and insert hose to fill. The clear tube below
the fill port has 19L (5 gallon) increment markers
to indicate amount of water in tank (Figure 12).
NOTE: The water must not be hotter than 60_C
(140_F) or tank damage may occur.
FIG. 12
NOTE: If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
OPERATION
FIG. 11
9