Machine Operation; Pre--Operation Checks; Operating The Machine - Tennant 5540 Manual Del Operador

OPERATION
5. Pour a recommended cleaning detergent into the
solution tank according to mixing instructions on
the bottle.
ATTENTION: Only use recommended cleaning
detergents. Machine damage due to improper
detergent usage will void the manufacturer's
warranty.
WARNING: Fire or Exposion Hazard.
Never Use Flammable Liquids.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Fire or Explosion Hazard. Never
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
PRE- -OPERATION CHECKS
1. Sweep and dust mop the floor.
2. Check battery meter charge level to ensure
batteries are fully charged (See CHARGING
BATTERIES).
3. Check that pads or brushes are installed.
4. Check that squeegee is installed.

OPERATING THE MACHINE

1. Adjust control grips to a comfortable operating
height (three settings). Squeeze two levers
together, located under console, to raise and lower
control grips (Figure 13).
10
FIG. 13
Home Find... Go To..
2. Lower squeegee. Depress thumb lever on
squeegee lift lever to lower (Figure 14).
FIG. 14
3. Lower scrub head. Depress top brush lift foot
pedal forward to lower (Figure 15).
FIG. 15
4. Turn on the main, vacuum and brush switches.
NOTE: The brush motors will not start until control
grips are rotated.
5. Activate solution flow. Push solution flow lever
slightly forward to activate. The further the lever is
pushed forward the more solution will flow. Push
completely forward for maximum flow. Solution will
immediately begin to flow once lever is activated
(Figure 16).
FIG. 16
Tennant 5540/5560 (08- -05)