Flex FX3171A Manual Del Operador página 12

remove the battery pack before performing
any assembly.
TO INSTALL A WHEEL: (FIG. 4-5)
a. Remove the battery pack from the tool.
b. Place the backing flange on the spindle,
making sure that the flat surfaces on the
bottom of the backing flange are engaged
with the flat surfaces on the spindle.
c. Place the grinding or cut-off wheel (not
supplied) on the backing flange.
d. When installing the grinding wheel, position
it so that the raised, small-diameter portion
of the lock nut faces the hole in the grinding
wheel.
e. When installing the cut-off wheel, position it
so that the flat surface faces the cut-off wheel.
WARNING
installed properly, the wheel cannot be
properly tightened, and serious injury can
result.
f. While pressing the spindle lock, tighten
the lock nut by turning it clockwise with the
wrench supplied.
Do not reverse the lock
nut. If the lock nut is not
Fig. 4
Grinding
Wheel
Spindle
Grinding
Wheel
Spindle
Fig. 5
Cut-off Wheel
(Not Supplied)
Backing Flange
Spindle
-12-
Lock Nut
Backing
Flange
Lock Nut
Backing
Flange
Lock Nut
Cut-off Wheel
Guard