Setup Switches And Their Functions; Entering The Setup Mode And Its Basics - Ikegami ISD-A20 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5-2. SETUP switches and their functions

SET UP
U
L
R
D
E
Up Switch (U)
Down Switch (D)
Right Switch (R)
Left Switch (L)
Enter Switch (E)
* To enter the setup mode, hold down the E button longer than 2 seconds.

5-3. Entering the setup mode and its basics

5-3-1. SETUP MENU (Main menu)
      S E T U P   M E N U
→CAMERA ID        OFF
 LIGHT CONTROL
 GAIN
 WHITE BALANCE    ATW
 SYNC             INT
 MENU LOCK        OFF
 SETUP            EXIT
(1)CAMERA ID
(2)LIGHT CONTROL The backlight compensation and spot photometry modes are
(3)GAIN
(4)WHITE BALANCE The white balance mode is selected. The manual white balance
(5)SYNC
(6)MENU LOCK
(7)SETUP
* New settings are not saved if EXIT is selected to quit the menu.
The pushbuttons and their markings at left are provided on the back
of the camera.
Used to select SETUP items (up and down).
Used to modify the settings.
Used to enter and quit the setup mode and to save the settings.
Up to 24 characters can be displayed onscreen.
selected. The wide dynamic level and DC type iris lens are
adjusted.
The gain control and electronic sensitivity up modes are selected.
The electronic sensitivity multiplying factor is also selected.
settings are made.
The sync systems (INT and LL) are selected and set up.
The saved settings can be locked.
The EXIT, CANCEL or RESET action is selected and executed.
① EXIT:
Used to save the settings and to quit the menu.
② CANCEL: Used to return the settings to the previously saved
ones.
③ RESET:
Used to return the settings to the factory ones.
Hold down the E button longer than 2
seconds, and the menu at left appears
onscreen. A highlighted item is now selected.
E-6

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido