Before Installing The Appliance; Installation; Ambient Temperature; Before Placing Food In The Appliance - THOMSON THD 300 NF WH Manual De Instrucciones

BEFORE INSTALLING THE APPLIANCE

Before connecting your fridge freezer to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
The plug is the only way to unplug the appliance and should therefore be accessible at all times. To turn
off main power to the appliance, turn it off and then detach the plug from the outlet.
The appliance must be grounded. The manufacturer is not responsible for damages that may occur as a
result of usage without grounding.

INSTALLATION

Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to
direct sunlight nor near a heat source, e.g. a cooker, radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on each side of
the cabinet.
For uneven surfaces, front feet can be aligned.

AMBIENT TEMPERATURE

This appliance is designed to operate in ambient temperature between 16°C and 43°C (N/ST/T). If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly. If the
ambient temperatures are exceeded for long periods, the temperature in the freezer compartment will
rise above -18℃ and food spoilage may occur.

BEFORE PLACING FOOD IN THE APPLIANCE

 Remove all packaging.
 Allow the appliance to run empty for 2 – 3 hours so the compartments can cool to the appropriate
temperature.
 Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.

POWER FAILURE

If there is a power failure, do not open the door. Frozen food should not be affected if the power failure
lasts for less than 12 hours.
Do not refreeze frozen foods that have thawed completely. The food may be dangerous to eat.
5