Sime MURELLE HE 110 R Manual De Usuario página 78

Type C (separate ø 80 flues)
KEY
1 90° MF polypropylene curve (6 pcs.) code 8077450
2 a Polypropylene extension L. 1000 (6 pcs.) code 8077351
2 b Polypropylene extension L. 500 (6 pcs.) code. 8077350
3 Hinged tile code 8091300
4 Roof terminal kit L. 1381 code 8091204
4 a Coaxial roof exit terminal code 8091205
5 Polypropylene extension L. 250 with socket code 6296513
6 45° MF polypropylene curve (6 pcs.) code 8077451
7 Exhaust terminal code 8089501
8 Internal-external ring nut kit code 8091500
9 Air inlet terminal (supplied with unit)
10 Inlet/exhaust fitting code 8091401
11 Rubber gasket ø 80 (supplied as standard)
12 Condensation recovery L. 135 code 8092800
13 Coaxial exhaust ø 80/125 L. 885 code 8091210
TABLE OF LOAD LOSSES OF ACCESSORIES
90° MF polypropylene curve
45° MF polypropylene curve
Polypropylene extension L. 1000
Polypropylene extension L. 500
Coaxial roof exit terminal + Fitting (pos. 10)
Roof exit terminal L. 1381
Exhaust terminal
Air inlet terminal
Polypropylene extension L. 250 with socket
Coaxial exhaust L. 885 + Fitting (pos. 10)
Condensation recovery L. 135
WARNING:
- Installations with roof exit terminal (4a) and coaxial exhaust (13) require the use of a condensation
recovery (12) that has to be connected to the water drain siphon (waste water).
- The installation of the roof exit terminal (4a) requires the removal of the two ø 60 and ø 100 reducers.
- Before installing accessories, lubricate the internal part of gaskets with silicon-based products. Avoid
using oils and greases.
78
Type C (separate ø 80 flues and
When load loss of the individual accessories connected
exceeds i 4 mm H
the appliance, do as follows:
- set the installer parameter PAR 9 as indicated in
TABLE 2 (see point 3.3 to access the installer para-
meters).
TABLE 2
Load loss
(mm H O)
2
Inlet Exhaust
2,3 3,5
1,7 2,3
1,4 1,4
0,7 0,7
- 16,0
- 5,0
- 4,0
1,8 -
- proceed with calibrating CO
- 0,3
minimum capacity as specified in point 4.2.2.
- 17,0
5,8 -
coaxial exhaust terminal)
WARNING !
O, to assure correct operation of
2
Load loss PAR 9
(mm H O) (long chimneys)
2
0 - 4 0
4 - 8 1
8 - 12 2
12 - 16 3
16 - 20 4
20 - 24 5
24 - 28 6
28 - 32 7
32 - 36 8
36 - 40 9
40 - 42 10
at the maximum and
2
Fig. 7