Function Settings - Pioneer MVH-P8300BT Manual Del Usuario

Section
03 Operating this unit
Storing the tag information to this unit
1 Tune in to the broadcast station.
2 Press and hold M.C. if
while the desired song is broadcasting.
Storing the tagged information to your iPod
1 Connect the iPod to this unit and transfer this
unit's tag information to the iPod.
! The tagged songs and the song that you can
buy from the iTunes Store may be different.
Make sure to confirm the song before you
make the purchase.
! If you cannot use this function normally, up-
date your iPod firmware.
! The tag information for up to 50 songs can be
stored on this unit.
Depending on the timing of when the tag in-
formation is stored, the tag information for the
song played before or after the currently play-
ing song may also be stored.
! If an SD is selected as the source while tag in-
formation is being stored to this unit, the tag
information will not be transferred to the iPod.
! Tag information cannot be transferred to the
iPod when a file on an SD device is being
viewed as a slideshow.
! While transferring the tag, you cannot select
the SD source.

Function settings

1 Press M.C. to display the function
menu.
2 Turn M.C. to select the function.
After selecting, perform the following proce-
dures to set the function.
BSM (best stations memory)
BSM (best stations memory) automatically stores the
six strongest stations in the order of their signal
strength.
1 Press M.C. to turn BSM on.
To cancel, press M.C. again.
16
En
appears in the display
Local (local seek tuning)
Local seek tuning lets you tune in to only those radio
stations with sufficiently strong signals for good re-
ception.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the desired setting.
FM: Off—Level1—Level2—Level3—Level4
AM: Off—Level1—Level2
The highest level setting allows reception of only
the strongest stations, while lower levels allow the
reception of weaker stations.
3 Press M.C. to confirm the selection.