Using Ground Coffee; Filling With Water - melitta BARISTA TS SMART Manual De Instrucciones

Basic operation
Filling with coffee beans
1. Open the lid of the 2-chamber bean
container (2).
2. Fill coffee beans into the bean cham-
bers.
3. Close the lid of the 2-chamber bean
container.
The "BEAN SELECT" button (30)
(BARISTA TS model) or the "Bean Select"
slider (3)(BARISTA T model) can be used
to select a bean type prior to preparation
(see section 5.6, page 49).

4.6 Using ground coffee

Ground coffee may also be used to pre-
pare coffee beverages.
ATTENTION
The use of unsuitable types of coffee can
lead to clogging of the brewing unit.
Do not use any instant products.
ƒ
Fill a maximum of one coffee spoon of
ƒ
ground coffee into the ground coffee
chute.
Fig. 10: Ground coffee chute
1. Open the lid of the ground coffee
chute (4).
2. Use the enclosed coffee spoon for
dosing.
Fill a maximum of one coffee spoon of
ground coffee into the ground coffee
chute.
3. Close the lid of the ground coffee
chute.
4. Proceed as described in sections 5 to 7.
46
Information
ū Two-cup dispensing is not possible
when using ground coffee.
ū If no coffee is prepared within 3
minutes of opening the ground coffee
chute, the appliance switches to opera-
tion with coffee beans and the ground
coffee is discharged into the coffee
grounds container.

4.7 Filling with water

Only use fresh, cold water without carbon
dioxide for optimum coffee enjoyment.
Change the water daily.
Information
The quality of the water largely determines
the flavour of the coffee. Therefore, use a
water filter (see section 9.8, page 60 and
section 9.9, page 60).
1
4
Fig. 11: Water tank
1. Open the lid of the water tank and pull
the water tank (1) upwards out of the
appliance by the handle.
2. Fill the water tank with water.
Note the maximum capacity of 1.8
litres.
3. Insert the water tank into the appliance
from above and close the lid.