Removing The Hook Cover Plate; Inserting The Bobbin - Janome MS 5027 Pink ribbon Manual De Instrucciones

• Removing the hook cover plate

Hook cover plate release button
1
2 Hook cover plate
Slide the hook cover plate release button
and remove the cover plate

• Inserting the bobbin

1 End of thread
2 Notch
Notch
3
Threading diagram
4
Place a bobbin in the bobbin holder with the thread
1
running off counterclockwise.
Guide the thread into notch
2
the bobbin holder. Draw the thread to the left, sliding it
between the tension spring blades.
Continue to draw the thread lightly until the thread slips
3
into notch . Pull out about 6" (15.0 cm) of thread.
3
4 Attach the hook cover plate. Check the threading by
referring to the diagram
to the right,
1
.
2
on the front side of
2
shown on the hook cover plate.
4
1
1
2
3
3
4
26
1
2
2
1/8 3/8 5/8
10
4