Janome MS 5027 Pink ribbon Manual De Instrucciones página 89

Mark for placement of buttonhole
3
Starting point
4
Slider
5
There should be no gap.
6
Spring holder
7
Difference
8
3 Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the needle
into the fabric to the starting point.
Then lower the automatic buttonhole foot.
Depress the foot control to sew a buttonhole. The
machine will stop when the buttonhole is completed.
4 Remove the fabric and place a pin just before the
bartack at each end, to prevent cutting bartacks. Cut the
opening with the buttonhole opener.
To sew another buttonhole, you must reset the machine.
5
Reset by shifting the stitch selector in either direction,
or , to the next setting. Then shift the selector back
9
10
to the buttonhole setting " ".
When finished, push the buttonhole lever up as far as it
6
will go.
3
3
4
5
6
82
4
8
9
10
5
6
7