NEFF F 3470 Instrucciones De Montaje E Instalación página 35

Fit an omnipolar cut-off device with a contact gap of
at least 3 mm to the mains cable of the appliance.
Do not use reduction pieces, adapters, parallel
connections or switches.
Position the cut-off device close to the appliance. The
yellow/green earth cable must be excluded from
disconnections.
The electric cable must not touch elements that are
50 °C higher than room temperature.
Type of current supply It is possible to make different voltage-dependent
connections by simply connecting the non-connected
cable ends to the terminal strip. The terminal strip is
located in the terminal box to the top left on the back
of the appliance (see illustration).
When connecting, observe the following connection
diagrams.
A C
B
Ex factory, this appliance is designed to be
connected in accordance with connection diagram C.
You can reverse the polarity of the appliance in
accordance with connection diagram A and B.
33