SCHUBERTH C3 pro Manual De Usuario página 36

C. THE HELMET
3. The anti-fog lens should now be
positioned in the face shield with its
lower edge parallel to the lower edge of
the face shield. If you need to change
the positioning of the anti-fog lens, use
the balls of your thumbs to gently bend
the face shield apart until the inner
visor can be adjusted as required.
4. Check all around the anti-fog lens to
make sure that it fits tightly and evenly
against the face shield. Only if this is
the case will the anti-misting properties
function properly.
5. If you have not done so already, remove
the protective film from the anti-fog
lens.
If the anti-fog lens is not air-tight and the face shield mists up, either the
visor is not correctly in place or the pressure on the seal is inadequate.
You can regulate the pressure on the seal by adjusting the eccentric
locking-pins. To do so, remove the anti-fog lens, then use a flat object with
no sharp-edges to push the locking pins out of the face shield carefully from
the inside; then rotate them by 180° and reinsert them. Fit the anti-fog lens
and check the seal.
Removal
1. Before starting to remove the anti-
fog lens, first lay the face shield on a
soft, clean cloth so that its top edge is
facing you.
68
2. To reduce the pretensioning of the anti-
fog lens slightly if necessary, use the
balls of your thumbs to carefully bend
the face shield sufficiently apart while
applying pressure with your thumbs to
release the anti-fog lens and move it
approx. 2–3 mm forward.
3. Now grip the back of the anti-fog lens
with your index and middle fingers and
lift it off the face shield. In this position
you can easily remove the anti-fog lens
from the locking pin with your thumb.
4. You can now remove the anti-fog lens
from the face shield.
Note:
To avoid scratching the face schield, never remove or fit the anti-fog
lens unless the visor unit is clean and dry.
When fitting the anti-fog lens, check that neither dust nor moisture are
able to get between the two surfaces.
When removing or fitting the anti-fog lens, it is always best to lay the
face schield unit on a clean, dry cloth.
Note:
In view of the strong air pressure acting when travelling with an open
face shield, we recommend riding with a closed face schield at all times
to prevent any dirt or moisture from getting inside the helmet.
Note:
Never press the locking pins out with your fingers as they may break.
EN
69