Safety Advice Concerning The Face Shield / Sun Visor; Safety Advice Concerning Modifications / Accessories; Maintenance And Care; Outer Shell - SCHUBERTH C3 pro Manual De Usuario

F. FOR YOUR SAFETY
2. SAFETY ADVICE CONCERNING THE FACE SHIELD /
SUN VISOR
The protective film used during shipping should be removed before use.
Any scratches and/or dirt arising from the use of the face shield and/
or sun visors significantly impair your vision in any driving situation and
thus increase the risk of an accident. For your own safety, replace them
or clean them immediately.
Never use a tinted face shield or sun visor in conditions of poor visibility,
at night or in a tunnel!
Benzine, solvent and fuel vapour can cause cracks in the face shield.
Keep the face shield away from such vapours and do not allow these
kinds of substances to come into direct contact with the face shield!
Never place the helmet on the tank of your motorcycle.
Make sure the face shield is always in perfect condition. Don't ride
when visibility is poor!
3. SAFETY ADVICE CONCERNING MODIFICATIONS /
ACCESSORIES
Original components (in particular on the outer shell, inner shell
and restraint system) should not be altered or removed. The fitting
of additional parts from other manufacturers that have not been
recommended can reduce the protective effect and renders the ECE
certification and all warranty and insurance claims invalid.
Use only original parts, replacement parts and accessories that
SCHUBERTH has expressly approved for your helmet!
90
G. MAINTENANCE AND CARE

1. OUTER SHELL

To clean the helmet shell, you can use water, soap or one of the commonly
available motorcycle shampoos, cleaners, polishes, plastic cleaners or
cleaning fluids. Using water and soap is usually sufficient. Make sure when
using the other cleaning materials that these do not come into contact with
the face shield, since they can cause damage to the visor and its coating.
Note:
Never use motor fuel, thinners or solvents to clean the helmet. These
substances can cause serious damage to the helmet with no external
signs. The full safety function of the helmet can then no longer be
guaranteed.

2. CHIN SECTION

Please check the functionality of the chin part at regular intervals.
Caution:
Alterations to the strap buckle are not permitted. In particular,
you should not oil or grease the metal components of the chin
section lock. Repairs may only be carried out by the SCHUBERTH
Repair Service.

3. FACE SHIELD AND SUN VISOR

OUTER SURFACE OF THE FACE SHIELD
Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt from the
outside of the face shield. To dry the face shield, use a lint-free cloth and
apply gentle pressure.
EN
91