Machine Setup; Preparing Machine For Readyspace Cleaning - Tennant READYSPACE 1610 Manual Del Operador Y Piezas

OPERATION

MACHINE SETUP

PREPARING MACHINE FOR READYSPACE CLEANING

FOR SAFETY: Before preparing machine,
turn machine off and remove key.
Step 1:
Unlatch the idler plates and remove
the two extractor brushes if installed.
IDLER
PLATE
(2) 6mm SOCKET
HEAD CAP SCREWS
Step 2:
Disconnect the vacuum hose and
remove the extractor vacuum shoe if installed.
6mm hex head tool required.
Step 3:
Install the two ReadySpace Rollers.
VACUUM HOSE
Step 4:
Install
the ReadySpace
vacuum shoe. Use
the screws removed
from Step 2.
Connect the
vacuum hose and
the vacuum tube as
shown.
(2) 6mm SOCKET
HEAD CAP SCREWS
Step 5:
Connect the solution flush line to the vacuum shoe
(See DETAIL). Repeat for opposite side.
10
All manuals and user guides at all-guides.com
VACUUM
TUBE
READYSPACE
VACUUM SHOE
Equipment Needed:
1) Two ReadySpace Rollers
2) Rear ReadySpace
Vacuum Shoe
3) 6 mm Hex Head Tool
(supplied with machine)
EXTRACTOR
VACUUM
SHOE
SCRUB HEAD
SOLUTION
FLUSH LINE
3 1
2
DETAIL
Push the retainer tab
upward to engage the
solution flush line tip.
Tennant 1610 (11- -04)