Machine Setup; Attaching Squeegee Assembly; Installing Brushes/Pads - Disc Scrub Head Model; Installing Brushes/Pads - Tennant 5400 Manual Del Operador

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY

1. Turn key to the off position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
2. Raise squeegee mount bracket using squeegee lift
lever (Figure 3).
FIG. 3
3. Loosen two thumb knobs on squeegee and slide
squeegee into slots of squeegee mount bracket.
Tighten thumb knobs securely (Figure 4).
FIG. 4
4. Connect vacuum hose to squeegee assembly,
make sure vacuum hose forms a trap using rubber
band provided (Figure 5).
FIG. 5
Tennant 5400 (07–02)
Home Find... Go To..

INSTALLING BRUSHES/PADS

(DISC Scrub Head Model)
NOTE: Consult an authorized distributor for pad/brush
recommendations.
1. Press bottom half of brush pressure switch until
scrub head is completely raised (Figure 6).
FIG. 6
2. Turn key to the off position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine,
and set parking brake, if equipped.
3. Attach pads to pad drivers before installing
drivers. Secure pad with centerlock (Figure 7).
FIG. 7
OPERATION
9