Installing The Decorative Cover - Progress Lighting AirPro P250024 Manual De Instalación

CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1. Remove the 1 of 3 screws from the
posts of the mounting ring and keep it for
future use. Loosen the other 2 screws. (Do not
remove)
Step 2. Place the key holes in the mounting
plate over the two screws previously loosened
from the mounting ring. Turn the mounting
plate until the decorative cover locks in place
at the narrow section of the key holes. (Fig.
13)
Step 3. Securely tighten the two mounting
screws previously loosened and the one
previously removed.
Step 4. Remove the four screws from the
mounting plate, attach the decorative cover to
the mounting plate and secure with the three
screws previously removed.
Mounting
plate
Decorative
cover
Figure 13

Installing the Decorative Cover

Installing the battery
Install a 12V battery (included) into the remote
control. To prevent damage to the remote control,
remove the battery if not used for long periods. (Fig.
14)
Mounting
ring
Screws
Screws
Figure 14
ON ECE
1 2 3 4
8.