Husqvarna K 7000 Manual Del Usuario página 11

2. Push the power trigger lockout and make sure that it
goes back when you release it.
3. Make sure that the power trigger and power trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full speed. Refer to
start the product on page 24 .
1635 - 003 - 20.08.2021
5. Release the power trigger and make sure that the
cutting blade stops in less than 10 seconds and
stays stationary.
Blade guard and SmartGuard (Optional)
WARNING:
guard and SmartGuard are correctly
attached before you start the product. Do
not use the product if the blade guard or
SmartGuard is missing, defective or has
cracks.
The blade guard (A) and SmartGuard (B) are installed
above the cutting blade (C). They prevent injury if pieces
of the blade or cut material are thrown in the direction of
the operator.
To
The SmartGuard is spring loaded and must always
move freely and retract to its initial position by spring
force.
To examine the blade and the blade guard
WARNING:
can cause injury.
1. Make sure that the cutting blade is attached correctly
and does not show signs of damage.
2. Make sure that the blade guard has no cracks or is
damaged.
Make sure that the blade
A
B
C
A damaged cutting blade
11