Husqvarna K 7000 Manual Del Usuario página 27

1. Loosen the 2 bolts that hold the cutting head to the
product.
2. Turn the adjuster screws until the adjustment nut is
opposite the mark on the drive belt cover.
3. Use a combination wrench and tighten the 2 bolts
that hold the cutting head to the product.
To replace the drive belt
1. Turn the bolt for the cutting blade counterclockwise
with a wrench to remove the cutting blade.
2. Loosen the 2 bolts and then the adjuster screw to
release the belt tension.
1635 - 003 - 20.08.2021
3. Remove the 2 bolts and remove the belt guard.
4. Remove the belt from the pulley.
Note:
The cutting head can be removed from the
product.
5. Loosen the 2 screws that hold the belt guard.
6. Remove the rear belt guard.
7. Replace the drive belt.
8. Assemble in opposite sequence. To install the
cutting blade, refer to
page 16 .
To install the cutting blade on
27