Assembly - Husqvarna K 7000 Manual Del Usuario

Ocultar thumbs Ver también para K 7000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cutting blades
WARNING:
gloves when you assemble the product.
WARNING:
and cause injury to the operator.
WARNING:
for cracks, lost segments distortion or
unbalance prior to use and immediately after
striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
blade. Read and obey the instructions that
are supplied with the cutting blade.
Diamond blades
WARNING:
very hot when used. A diamond blade that is
too hot gives bad performance, blade
damage and is a safety risk.
WARNING:
blades to cut plastic material. The hot
diamond blade can melt the plastic, which
can cause a kickback.
Diamond blades have a steel core with segments
that are made of industrial diamonds.
Diamond blades are used for masonry, reinforced
concrete and stone.
1635 - 003 - 20.08.2021

Assembly

Always use protective
A cutting blade can break
Examine the cutting blade
The cutting blade
Diamond blades become
Do not use diamond
Make sure that the diamond blade rotates in the
direction of the arrows shown on the diamond blade.
Always use a sharp diamond blade.
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause
the diamond segments to come loose.
Cutting blades for handheld high speed
power cutters
WARNING:
Do not use blades with serrations such as
circular wood cutting blades or blades with
carbide tips. The risk of kickback is
increased and carbide tips can come off and
be thrown at high speed. This can result in
injury or death.
WARNING:
the blade to become too hot. A blade that is
too hot can cause malfunction, which can
cause damage and injury.
WARNING:
with a lower maximum speed than that of
the power cutter. Only use cutting blades
that are in compliance with national or
regional standards.
Note:
Only cut materials approved in the instruction
supplied with the blade.
Check that the blade is approved for the same or higher
speed written on the type plate of the power cutter.
Only use diamond blades.
Incorrect use can cause
Do not use a cutting blade
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K 7000 smartguard

Tabla de contenido