Husqvarna K 7000 Manual Del Usuario página 12

3. Replace the blade guard if it is damaged.
To do a check of the SmartGuard
WARNING:
can cause injury.
CAUTION:
guard and can become damaged by heat
during intense dry cutting of metal with
bonded abrasive blades. Do not do intense
dry metal cutting and let the product become
cool between the cuts. For intense metal
cutting with SmartGuard, we recommend
wet cutting together with vacuum brazed
diamond blades, such as VARI-CUT FR3.
1. Make sure that the SmartGuard has no cracks or
damage.
2. Make sure that the SmartGuard moves freely without
much play and retracts by spring force.
3. Clean or replace the SmartGuard if it does not
retract immediately when pushed in, or is damaged.
Start and overload protection
The product has an electronically controlled start and
overload protection, Elgard
current immediately if the blade does not move freely.
12
A damaged SmartGuard
The SmartGuard is a plastic
™
. The electronics stop the
For explanation of the indication lamps, refer to the table
Lamp indicators in the product on page 25 .
in
Vibration damping system
Your product is equipped with a vibration damping
system that is designed to minimize vibration and make
operation easier. The product's vibration damping
system reduces the transfer of vibration between the
motor unit/cutting equipment and the product's handle
unit.
To do a check of the vibration damping
system
WARNING:
off and that the power plug is disconnected.
1. Make sure that there are no cracks or deformation
on the vibration damping units. Replace the vibration
damping units if they are damaged.
2. Make sure that the vibration damping units are
correctly attached to the motor unit and handle unit.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• Make sure that the motor is off and that the power
plug is disconnected.
• Use personal protective equipment. Refer to
Personal protective equipment on page 9 .
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Let an approved HUSQVARNA service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
• Always use original accessories.
Make sure that the motor is
Read the warning
1635 - 003 - 20.08.2021