Nterrupting Se Total Stop - EMAK PW 160 Manual De Istrucciones

Never suck up liquids, which contain solvents, petrol, diluents, acetone and fuel oil, as these
products are highly inflammable, explosive and toxic when nebulized.
• Carefully read the instructions and warnings on the label of the detergent to be used.
• Store detergents in a safe place out of children's reach.
• Should detergent come into contact with your eyes, wash immediately with water. Contact a
doctor without delay and remember to take the container of detergent with you.
• If detergent is swallowed, do not provoke vomiting. Contact a doctor without delay and
remember to take the container of detergent with you.
• When filling the tank with detergent, take care not to spill any detergent on the high pressure
cleaner. If this should happen, wait at least 24 hours before using the high pressure cleaner
so that any liquid, which may have entered the appliance, can evaporate.
The recommended detergents, are over 90% biodegradable.
For information on how to use the detergents, refer to the instructions in the table and on the label
on the container of detergent.
• In case of suction from the water cleaner tank (only PW 170C - IP 1700S):
- Remove the plug (4) and, by paying attention that the fluid does not overflow, fill the tank
(maximum capacity 1.75l/0.46 US gal.) by following the recommendations relating to the
proportion indicated on the detergent package label.
- Operate the nozzle-holding multi-adjusting head (12) as shown in Fig. H-1 and activate the
water gun lever (9) and start the detergent spraying operation.
- Operate the nozzle-holding multi-adjusting head (12) as shown in Fig. H-2 to reset the high-
pressure operation.
• In case you use the foaming lance (31) (only PW 160 - IP 1600), insert it on the water gun (8)
and switch on the device (the suction and the mixing take place automatically when the water
flows by).
5.4 I U
NTERRUPTING
Release the lever (9) on the cleaner gun and the water cleaner will automatically stop.
The water cleaner starts operating normally again when the lever on the cleaner gun is pressed
again.
fi«
CAUTION
• It is important to remember that the high pressure cleaner is still operational when it is in Total
Stop mode. Therefore, always put the main switch (1) in position "0", remove the plug from
the power outlet, press the lever (9) on the cleaner gun to eliminate any remaining pressure
and lock the safety protection device (10) (Fig. B), before leaving it unattended, even for a
short time.
46
( )
SE TOTAL STOP