Foppapedretti UP3 Manual De Instrucciones página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37
ASSEMBLY
(fig.24, fig.25, fig.26)
OPEN THE CANOPY (fig.27, fig.28)
As picture, follow the arrowhead, pull the canopy pole and press down the agraffe, then the canopy
can be opened.
FOLD THE CANOPY (fig.29, fig.30, fig.31)
Follow the arrowhead, put up the agraffe upward, then push the canopy, the canopy can be folded
(fig.31).
IMPORTANT: Never close the canopy without first undo the stretchers. The canopy could be
damaged.
ADJUST THE FOOTREST
Press buttons "A" and adjust the footrest in the required position.
RECLINE THE BACKREST
To catch hold of the belt with one hand, and push up the Adjusting Holder "a" as shown in picture.
Press the button situated on the center of the Holder "b" with your thumb and pull the holder.
REVERSIBLE SEAT
(fig.35, fig.36, fig.37)
Lift buttons "A" on both sides and remove the seat by lifting it.
Position the seat so that it is forward facing or parent-facing.
Replace the seat on the chassis of the pushchair, see the paragraph "INSTALL THE SEAT" for correct
assembly.
SAFETY HARNESS
(fig.38)
Apply the brake before placing your baby in the pushchair.
Release the buckle: press button "A" and remove the components.
Fasten the buckle: by inserting part "a" in part "b", a click will indicate that it has been fastened
correctly.
WARNING: The lap belt is provided with 2 side rings to be used for additional belts in compliance with
the standard BS 6684.
FOLDING THE PUSHCHAIR
Before folding the pushchair, make sure that:
• The seat is forward facing
• The backrest is adjusted in the upright position
• The canopy is folded.
Push the button "A", on the lower side of the right lever and keep pressed while sliding the levers, left and
right, downwards. Fold the stroller. Ensure the locking device "B" is correctly engaged (fig.42).
Note: It is NOT possible to close the pushchair with the travel system accessories, the infant car seat
and carrycot, fitted on the chassis.
UNFOLD THE STROLLER
Press the folding lock button and then lift up the handlebar to open the folding lock.
Step on the lever, and then lift up the handlebar until the stroller is unfolded.
Make sure the pushchair has been opened correctly.
• ENGLISH •
ASSEMBLY
(fig.33)
(fig.34)
(fig.39, fig.40, fig.41, fig.42)
(fig.43, fig.44, fig.45)
17

Publicidad

Tabla de contenido
loading

Tabla de contenido