Foppapedretti UP3 Manual De Instrucciones página 18

• ENGLISH •
ASSEMBLY
FITTING THE FOOTMUFF
(fig.46)
Insert the lower part of the footmuff on the seat of the chassis.
Secure the footmuff to the chassis of the pushchair.
FITTING THE PUSHCHAIR RAINCOVER
(fig.47)
Fit the raincover over the hood.
Fasten the front of the raincover to the chassis of the pushchair using the Velcro tabs.
USING THE TRAVEL SYSTEM ACCESSORIES
WARNING: This vehicle has been designed for children of above 6 month age!
If you wish to use one of the accessories with which you can equip with your chassis car seat UP3
of the Group 0+ or carry cot UP3 developed for when your baby is small, pls. Operate it by following
these instruction.
Remove the seat from the chassis (see the paragraph "INSTALL THE SEAT").
USING THE INFANT CAR SEAT AND CARRYCOT TRAVEL SYSTEM ACCESSORIES
(fig.48, fig.49)
IMPORTANT: the travel system accessories must be secured to the chassis only in the parent facing
position.8
CARRY COT
(fig.50, fig.51)
Montage: Align the carry cot with the adaptors at both side, and press until "click" sound.
Remove: Lift up the buttons of the adaptors with one finger at each side and lift up the seat to
remove the carry cot.
ADJUST CANOPY
(fig.52, fig.53, fig.54)
Assembly (fig.52, 53)
Press the buttons at both side to adjust he handlebar of carry cot.
ADJUST THE BACKREST
(fig.55)
Lift up the adjusting Holder to adjust the backrest up, press the button situated on the upper part of
the Holder and push the Holder down to adjust the backrest down.
Hook the support bar to the frame to prevent swinging movement of the carrycot when using it on
uneven terrains.( fig.56)
CAR SEAT (fig.57, fig.58)
Montage: Align the carry cot with the adaptors at both side, and press until "click" sound.
Remove: Lift up the buttons of the adaptors with one finger at each side and lift up the seat to
remove the car seat.
18