Troubleshooting - Husqvarna Rider 214T Manual De Usuario

Ocultar thumbs Ver también para Rider 214T:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line.
Technical data on page 27 for
Note: See
recommended oil for Rider 214T, Rider 214TC and
Rider 216T AWD. Rider 216T AWD must have a
synthetic oil.
To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt shield and lift
it off.
Troubleshooting schedule
If you cannot find a solution to your problems in this
owner's manual, speak to your Husqvarna service
agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
24

Troubleshooting

Cause
The parking brake is not applied. See
page 14 .
The lift lever for the cutting deck is in mow position. See
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
page 9 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
2. Lubricate with a grease gun, 1 nipple from the right
side below the lower belt pulley, until grease is
forced out.
3. Attach the belt shield and tighten the 2 screws.
To apply and release the parking brake on
To replace the main fuse on page 18 .
To charge the battery on page 18 .
To fill fuel on page 11 .
Safety circuit on page 8 .
Battery safety on
345 - 003 - 28.11.2017

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rider 214tcRider 216t awd

Tabla de contenido