Vehicle Compatibility; Compatible Vehicle Seat Belts - Britax ROUNDABOUT 55 Guia Del Usuario

Vehicle Compatibility

Compatible Vehicle Seat Belts

NOTE: The information in this section only applies to installation
with vehicle seat belts.
Vehicle seats and seat belts differ from vehicle to vehicle. Refer to
your vehicle owner's manual for specific information about your
vehicle seat belts and their use with child seats.
Lap-Shoulder (3-Point) Belt
1. ALR (Automatic Locking Retractor) with Sliding Latch Plate
Has a latch plate that freely
a
slides along the vehicle seat
belt webbing.
Has a retractor that stops the
b
belt from being pulled out
again once the belt webbing
has been pulled out at least
24 in. (61 cm).
Tightens by feeding the
c
belt webbing back into the
retractor.
2. ELR (Emergency Locking Retractor) with Locking Latch Plate
Has a latch plate that locks
a
the vehicle belt.
* This type of latch plate locks
the vehicle belt when the
vehicle belt and latch plate lie
flat. When using this type of
vehicle belt with a child seat,
ensure the latch plate and
vehicle belt lie flat against the
child seat or the vehicle belt
may remain unlocked.
Has a retractor that locks
b
only in an emergency
situation such as sudden
stop or crash.
3. Switchable Retractor in ALR Mode with Sliding Latch Plate
Has a latch plate that freely
a
slides along the vehicle
seat belt webbing.
6
b
4. ELR (Emergency Locking Retractor) with a Sliding Latch Plate
a
Latch
plate
b
IMPORTANT: This belt type requires
the use of the lock-offs built into the
seat for rear- and forward-facing installations. See page 14 for information on
using the lock-offs.
Lap Belt
5. ALR (Automatic Locking Retractor)
a
b
Latch
plate
c
Latch
plate
Has a retractor that can be
switched to function as an
ALR. Pull the belt all the
way out of the retractor to
set the automatic locking
function.
* To use a child seat with this
type of vehicle seat belt, you
will need to switch to the
ALR mode or use child seat lock-offs.
Has a latch plate that freely
slides along the vehicle
seat belt webbing.
Has a retractor that locks
only in an emergency
situation such as sudden
stop or crash.
Has a latch plate that is
sewn into the webbing.
Has a retractor that stops the
belt from being pulled out
again once the belt webbing
has been pulled out at least
24 in. (61 cm).
Tightens by feeding the
belt webbing back into the
retractor.
Vehicle Compatibility
Latch
plate
7