Starting The Machine - ENAR REN650DK Manual De Instrucciones

3.5 STARTING THE MACHINE

•
•
•
Cautions when starting the engine
•
•
•
•
en
•
Be careful of the exhaust
•
REN650DK
8
When starting and operating the machine, stand beside it.
When operating the machine indoors, be careful of the exhaust and perform ventilation well.
If abnormal noise or smoke has occurred, stop the machine, search for its cause and repair the
defective part.
Before starting the engine, check the safety around the
machine.
When there is a co-worker, give a signal to him/her to
prepare for the operation.
During the operation, be careful to prevent infants or
livestock from coming near the engine.
When starting with the start handle:
- When starting, fit the start handle´s claw to start shaft´s
pin securely.
- If the start handle´s claw is deformed (worn or missing) or
if its fitting status is not good, do not use the claw but
replace it with a new one.
- Even after the engine has started, hold the start handle
securely and do not release it.
When starting with "self-start":
- Do not start the engine by shorting the starter circuit. This
start method is dangerous and sometimes, damages the
machine.
The exhaust of the engine includes carbon monoxide and
others that are harmful for human body.
- Do not run the engine where ventilation is not done well.
- During the operation, protect not only the operator but also
the people and livestock around the machine from the
exhaust.
DUPLEX VIBRATING ROLLER