Cautions During Operation - ENAR REN650DK Manual De Instrucciones

3.6 CAUTIONS DURING OPERATION

•
Before the operation, make sure that there is not a person and obstacles at the front and rear of
the machine.
•
Be very careful when operating the machine on a slope.
•
On a hard ground (concrete or frozen ground), do not operate the machine with vibration.
Cautions to protect yourself from burn
•
During and right after the engine operation, the muffler,
muffler cover, radiator, pipes, engine body, cooling water
and engine oil are hot. IF your hand or skin touches them,
you may be burned.
- After the operation, wait until the engine and radiator are
fully cooled (30 minutes or more since the engine stopped).
Then, carry out your work.
- After the engine has stopped, wait until the cap at the
radiator´s filler port is fully cooled (until you can touch it by
bare hand). Then, remove the cap.
- First, loosen the cap slowly to the firs stop and discharge
all of pressure. Then, turn the cap again and remove it.
•
If the engine is overheated, steam may blow off from the
radiator or reservoir tank. When your hand or skin touches
the steam, you may be burned.
- Do not stop the engine abruptly. Remove the load and, for
5 minutes or more, carry out "cooling operation" such as
idling to gradually cool the engine, Then, stop the engine.
•
If you keep running the engine with the broken cooling fan
or fan belt, the cooling device will be damaged or the engine
will be overheated. You may be burned.
- Before the operation, check if there is a crack or defective
part in the machine according to the periodic inspection
table. If any part is cracked or comes off, replace it with a
new one.
DUPLEX VIBRATING ROLLER
REN650DK
en
9