Publicidad
UPPER CASE
INSTALLING THE LOWER MOUNT
1. Install:
Lower front mount rubber
NOTE:
Set the "UP" mark upward.
2. Install:
Lower mount rubber housing
NOTE:
Install the mounting bolt while
confirming the identifying "V" mark on
its head.
Pass the stop switch lead wire together
with the throttle wire through the
corrugated tube, pass under the throttle
wire, and then insert in the grommet of
the bottom cowling.
Tighten 2 front bolts 1 to the specified
torque, then tighten 2 rear bolts 2 to the
specified torque.
Finally, check that all 4 bolts are tightened
to the specified torque.
7-22
Publicidad
Capítulos
