Lap-Shoulder Belt Installation - Britax ENDEAVOURS Guia Del Usuario

Britax Child Safety, Inc.

Lap-Shoulder Belt Installation

IMPORTANT: Check your vehicle owner's manual to
determine how to lock your vehicle belt system�
* If you cannot lock your vehicle seat belt you must
use a locking clip� Locking clips are available from
Britax at 1-888-427-4829 or 1-704-409-1699�
1� Secure your child in the
infant car seat before
installing the car seat in
the vehicle�
2� Place the infant car seat
rear facing on the vehicle
seat�
3� Pull the vehicle belt out
and only route the lap
portion through the carrier
only belt guides�
4� Verify that the vehicle belt
is not twisted and buckle�
Lock your vehicle seat
belt system as instructed
by your vehicle owner's
manual�
24
ENDEAVOURS/B-SAFE ULTRA User Guide
5� Push the infant car seat
firmly into the vehicle seat
while removing all slack
from the lap portion and
then the shoulder portion
of the vehicle belt�
Carrier Only Installation with Lap-Shoulder Belt
CHECKLIST
ü Check that the vehicle belt is tight and that the
infant car seat is secure� The infant car seat is
secure when it moves less than 1 inch (2�5 cm)
front-to-back or side-to-side at the vehicle belt path�
ü Check that the recline angle is correct� The proper
recline angle is achieved when the level line on the
carrier is level to the ground�
ü Check that the vehicle belt is not twisted and that it
is tight and locked�
ü Check that the infant car seat handle is rotated into
any locked position�
25