Installation In Booster Mode - Britax PINNACLE Guia Del Usuario

Britax Child Safety, Inc.

Installation in Booster Mode

Lower Anchors with CLICKTIGHT
Before you begin:
IMPORTANT: It is not necessary to use lower anchors or
tether to position this child restraint in booster mode� To
use this seat in booster mode without lower anchors, see
instructions for Securing Your Child on page 20�
IMPORTANT: Use lower anchors only to position this
child seat in your vehicle seat� Secure your child using the
vehicle's lap-shoulder belt system�
• Check that your vehicle has lower anchors�
• Check that your vehicle has a top tether anchor�
• Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during positioning�
• Adjust the child seat to the upright position and place
forward facing on the vehicle seat�
1� Release the buckle and
open the CLICKTIGHT
to access the lower
connectors�
a� Locate the two slots
in the CLICKTIGHT
cover�
b� Squeeze the
CLICKTIGHT release
levers�
2� Route the lower connector
strap along the green
belt path and firmly press
the lower connectors
onto their adjacent lower
anchors� A click confirms
attachment�
NOTE: Verify that the strap
is not twisted.
3� Pull the end of the lower
connector strap to remove
slack�
IMPORTANT: Only
remove slack from the
lower connector webbing�
Overtightening the
webbing may prevent the
CLICKTIGHT from properly
securing�
16
FRONTIER/PINNACLE CLICKTIGHT User Guide
4� Close the CLICKTIGHT�
A click confirms the
CLICKTIGHT is secure�
5� Firmly press the tether
hook over a designated
vehicle tether anchor�
Remove slack�
6� Secure excess webbing
with the elastic strap�
Or
Or
17