Information For Users - EdilKamin ROSE Instalación Uso Y Mantenimiento

REMOTE CONTROL code 633280 (optional)
: ignition / shutdown button
+ : button to increase the power/operating temperature (when inside a menu, it increases the displayed variable)
-
: button to increase the power/operating temperature (when inside a menu, it decreases the displayed variable)
A
: button to toggle from manual and automatic mode
M : button to toggle from automatic to manual mode
- the remote control transmits by means of an infrared signal within a range of 4-5 metres. The LED transmission signal must be
in line with the receiving LED of the stove for the signal to be transmitted correctly. This must also be in a free-field environment,
therefore, free of obstacles.
- the remote control works with 3 alkaline 1.5V AAA batteries. Their duration depends upon usage, however, the average duration
is that of an entire season.
- when a button is pressed, the backlight goes on, which indicates that the remote control is transmitting the signal. The "beep"
emitted by the stove confirms its reception.
- the remote control must be cleaned with a damp cloth and no detergents or liquids must be sprayed onto it. In any case, use neu-
tral detergents which are free from aggressive substances.
- handle the remote control with care. It could easily break if dropped, due to its size.
Moreover, all operations implemented from the synoptic panel can also be implemented from the remote control.
- The operating temperature is: 0-40°C
- The correct storage temperature is :-10/+50°C
- Operating humidity is: 20-90% R.H with no condensation
- Degree of protection is: IP 40
- Weight of remote control with batteries: 160gr
(Performed solely by the Dealer): An infrared remote control is easily identified through radio transmission as it has its tran-
smission LED at the tip. Refer to photo "A" below.
In accordance with Art. 13 of the Legislative Decree No. 151, dated 25 July 2005, "Implementation of Directives: 2002/95/
EC, 2002/96/EC and 2003/108/EC, pertaining to the reduction of hazardous substances used in electrical and electronic
equipment, as well as disposal of waste".
The crossed-out wheeled bin symbol shown on the equipment or on the packaging indicates that the product must be dispo-
sed of separately at the end of its useful life.
Therefore, at the end of the equipment's useful life, the user must hand in the equipment to suitable collection facilities for
electrical and electronic waste, or return it to the retailer when a new, equivalent appliance is purchased in a ratio of one to
one.

INFORMATION FOR USERS

- 22
-
Photo "A"