Arregui IGNUM 41050 Manual De Instrucciones Y Garantías página 4

<EN>
D. CHANGING THE OPENING CODE
D.1. USER CODE
• Press the # key and the screen will indicate "-------".
• First introduce the current opening code (1234 if it is the first time you
are doing this) and press # again. You will hear a beep and the screen
will indicate "OPEN".
• Press the * key and the screen will indicate "-------". Then introduce
a code with 4 to 8 digits and confirm it by pressing the # key. At that
moment, the screen will indicate "INTO", which means that the change
in code has been successfully produced.
• Check that the change in code has indeed been carried out BEFORE
CLOSING THE SAFE.
D.2. MASTER CODE
• Press the # key and the screen will indicate "-------".
• First introduce the current opening code (123456 if it is the first time
you are doing this) and press # again. You will hear a beep and the
screen will indicate "OPEN".
• Press the * key and the screen will indicate "-------". Then introduce
a code with 4 to 8 digits and confirm it by pressing the # key. At that
moment, the screen will indicate "INTO", which means that the change
in code has been successfully produced.
• Check that the change in code has indeed been carried out BEFORE
CLOSING THE SAFE.
WARNING:
• For your own security, it is recommended to change the opening code
as soon as you open the safe for the first time. This code change
must be carried out with the door open.
• If you introduce a wrong number, you can press the * key to delete it.
E. ALARMS FOR WRONG CODE OR IMPACTS
If you introduce a wrong opening code, the screen will indicate "ERROR" and
will give out 3 beeps. After the third consecutive wrong code, the keypad
will automatically become blocked and the alarm will sound for 60 seconds.
If you want the alarm to go off in the case of an impact or movement of the
safe, proceed as follows: after the door is opened, when the display goes
off, press the 0 key; the screen will indicate "BELL ON" and the alarm mode
will be activated.