Plumbing And Water Supply - Jacuzzi ALLUSION 6636 Manual De Instalación Y Operación

Drain Information
A drain/overflow kit with an electrically controlled valve
comes with this unit. Refer to page 6.
Plumbing
Pump, jets, and suction fittings for the whirlpool system
are factory plumbed in schedule 40 PVC piping.
All Jacuzzi Whirlpool Combination Bath products are fac-
tory tested for proper operation and watertight connections
prior to shipping. If leaks are detected, notify your Jacuzzi
Whirlpool Bath Dealer. Do not install the unit.
Water Supply
Consult local authorities for plumbing code requirements
in your area.
IMPORTANT: Proper installation of the fill spout plumb-
ing and compliance with local codes are the responsibil-
ity of the installer. Jacuzzi Whirlpool Bath does not war-
rant connections of water supply fittings and piping, fill
systems, or drain/overflow systems. Nor is it respon-
sible for damage to the bath which occurs during instal-
lation.
CAUTION: A nonflammable protective barrier must be
placed between soldering work and bath unit to prevent
damage to the bath.
Anti-Siphon Valve
Optional Anti-Siphon valve installation. The Anti-Siphon
valve is not supplied with the tub. Consult your local plumb-
ing code requirements for the minimum height above the tub
rim.
6"
BATH RIM

Plumbing and Water Supply

*ANTI-SIPHON VALVE
* NOT
PROVIDED
7
Clean-Up After Installation
To avoid dulling and scratching the surface of the bath,
never use abrasive cleaners. A mild liquid detergent and
warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal
tools will scratch the surface. Spots left by plaster or grout
can be removed if lightly rubbed with detergent on a damp
cloth or sponge.
Paint, tar, or other difficult surface stains can be removed
with paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol). NOTE: Use these chemicals only on SURFACE
stains.
Minor scratches which do not penetrate the color finish
can be removed by lightly sanding with 600-grit wet/dry sand-
paper. You can restore the glossy finish to the acrylic surface
of the bath with a special compound, Meguiar's #10 Mirror
Glaze. If that is not available, use automotive rubbing com-
pound followed by an application of automotive paste wax.
Major scratches and gouges which penetrate the acrylic
surface will require refinishing. Ask your Jacuzzi Whirlpool
Bath dealer for special instructions or visit our web site at
http://www.jacuzzi.com/ to find a service agent listing for Sur-
face or Shell-Related Problems.
Jacuzzi Whirlpool Bath© BR28000A 3/05