Installation Procedure - Toto CST446 Manual De Instrucciones

1. Open the Unifit Rough-In packaging.
Follow the Unifit Rough-In
Installation instruction to complete
the rough-in installation (ill. 1).
2. Place the template into position and
follow its instructions to prepare for
installing the toilet bowl.
Do not move the Unifit Rough-
NOTICE
In on the Floor Flange after
wax seal is set. If this notice is
disregarded, discard the wax ring
and replace with new wax ring.
3. Place the toilet bowl over the Unifit
Rough-In and the two mounting blocks,
by aligning the bowl outlet with the
Unifit Rough-In opening (ill. 2).
Insert the toilet all the way
NOTICE
into position. If this notice is
disregarded, leakage may result.
4. Align the toilet perpendicular to the
back wall and parallel to side walls; it
should not sit crooked or diagonal (ill. 3).

INSTALLATION PROCEDURE

4
ill.1
Wax seal
Screw
ill.2
ill. 3
Nut
Washer
Mounting block