Installation Procedure - Toto AQUIA IV CST446 Serie Manual De Instrucciones Y Del Propietario

1.
Installation instruction to complete
the rough-in installation (ill. 1).
2. Place the template into position and
follow its instructions to prepare for
installing the toilet bowl.
NOTICE
In on the Floor Flange after
wax seal is set. If this notice is
disregarded, discard the wax ring
and replace with new wax ring.
3.
Rough-In and the two mounting blocks,
by aligning the bowl outlet with the
Insert the toilet all the way
NOTICE
into position. If this notice is
disregarded, leakage may result.
Check for rocking. If needed, use
NOTICE
shims to prevent the toilet from
rocking.
4. Align the toilet perpendicular to the
back wall and parallel to side walls; it
should not sit crooked or diagonal (ill. 3).

INSTALLATION PROCEDURE

4
ill.1
Wax seal
Screw
Anchor
ill.2
ill. 3
Nut
Washer
Mounting block