Husqvarna ST 324 Manual Del Usuario página 10

3. Put the oil cap back.
To fill fuel
If available, use low-emission/alkylate gasoline. If
low-emission/alkylate gasoline is not available, use
good quality unleaded gasoline or leaded gasoline.
Use gasoline with an octane number of 90 RON out
of North America (87 AKI in North America) or
higher, and with a maximum of 10% ethanol (E10).
CAUTION: Do not use gasoline with an
octane number less than 90 RON out of
North America (87 AKI in North
America). This can cause damage to the
product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove
it with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap
is not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from
the position where you filled the tank, before a
start.
To adjust the discharge chute and
the chute deflector
1. To adjust the discharge chute position, move the
discharge chute control lever (A) back and to the
left or right direction.
2. To adjust the snow throwing distance of the
chute deflector, move the deflector remote
control lever (B) down to decrease the distance
and up to increase the distance.
B
To start the engine, manual start
1. Insert the ON/OFF key (A) into the ignition slot
until it clicks. Do not turn the key.
10
A
D
B
E
A
C
F
2. Turn the fuel ON/OFF switch (F) to the ON
position.
3. Put the throttle control (B) to the FAST position.
4. Put the ON/OFF switch (C) to the ON position.
a) If the engine is cold, rotate the choke (D) to
the FULL position and push the primer (E)
three times.
CAUTION: Do not over prime the
engine. It can prevent the engine
from starting. If the engine is over
primed, wait a few minutes before
attempting to start and do not
push the primer.
5. Pull the starter rope handle (G).
CAUTION: Do not release the grip
quickly. Move it back to the start
position slowly.
Note: If the rope starter has frozen, slowly pull
out as much rope out of the starter as possible
and release the starter rope handle. If the engine
does not start, repeat the procedure or use the
electric starter.
6. If the choke was used to start the engine, slowly
move the choke (D) to the OFF position.
7. Run the engine 2-3 minutes at idling speed
before you start to throw snow.
8. If the engine does not run as it should, turn it off.
To start the engine, electric start
WARNING: The product has a 120 V
A.C. electric starter. Do not use the
electric starter if your house is not a 120
V A.C. three-wire grounded system.
Serious personal injury or damage to the
product could occur. The electric starter
has a three-wire power plug, and is
G
690 - 004 - 17.12.2019