A
5. Put the cables through the cable guide (F) and
the double clip (I) to attach the rotator cable (H)
to the lower handle.
I
To install the chute deflector remote
control
1. Attach the remote cable bracket (A) to the
discharge chute with a carriage bolt (B) and a
5/16-18 locknut (D). Tighten the bolt.
Before you start the product
•
Keep persons and animals away from the work
area.
•
Do daily maintenance. See
schedule on page 14 .
•
Make sure the ignition lead fits correctly on the
spark plug.
•
Add oil or gasoline, if necessary. See
data on page 23 .
690 - 004 - 17.12.2019
G
F
B
D
C
E
H
F
Operation
Maintenance
Technical
2. Install the remote cable eyelet (E) to the chute
deflector (F) with a shoulder bolt (G), a nylon
washer (C), and tighten with a ¼-20 locknut (K).
The cable eyelet will be loose on the shoulder
bolt.
3. Attach the spring (L) between the hex nut (M) on
the chute rotator head and the hole on the chute
deflector.
G
C
E
K
D
A
4. Attach the lever control knobs (N) by pressing
them down on the control levers (O).
To fill the engine with oil
CAUTION: Do not rotate the dipstick
when you check the oil. Do not fill above
the mark.
1. Remove the oil cap and clean the dipstick. See
Product overview on page 2 for the location of
the dipstick.
2. Add oil to the top mark on the dipstick. Use the
dipstick to do a check of the oil level at regular
intervals.
F
L
M
B
N
O
9