Husqvarna ST 324 Manual Del Usuario página 12

C
4. To make the product move in the selected
direction, hold the drive engagement (C) against
the handle .
5. If the product has power steering, hold the left
steering trigger (D) to turn left. Hold the right
steering trigger to turn right.
To stop the product
1. Move the throttle control (A) to the STOP
position.
A
2. Remove the ON/OFF key.
To use the throttle control
• Turn the throttle control (A) to change the
amount of fuel used. Always operate the engine
at full throttle.
12
B
D
A
To use the fuel switch
• Turn the fuel switch to open or close the fuel
valve. Operate the product with the fuel switch in
the OPEN position.
OFF
To use the choke control
• Turn the choke (A) to open or close the choke
valve. Use the choke to start a cold engine.
A
To adjust the skid plates
No adjustment is required for normal installation.
1. When the lock nut (B) is loose or the skid plate
(A) is not high enough from the ground, unlock
the lock nut (B) with a 13 mm open-ended
wrench, to move the skid plate up or down.
2. On flat surfaces, like asphalt roads, raise the skid
plates (A) 5-6 mm (0.2-0.25 in) off the ground.
On uneven surfaces, like gravel roads, make the
clearance between the ground and the product
larger with the skid plates to get the scraper bar
above the top of the gravel. Make sure that the
FUE LCO NTR OL
INSTRU CTION S
ON
690 - 004 - 17.12.2019