Husqvarna ST 324 Manual Del Usuario página 19

A
2. Hold the short section and turn the long section
to increase the adjuster.
3. Adjust until the cable for the discharge chute
deflector (C) has a tight fit. Tighten the jam nuts.
To adjust the auger control cable
1. Remove the cable cover on the right hand side of
the frame (D).
2. To remove slack from the auger control cable,
unscrew the bottom jam nut (B) and tighten the
top jam nut (B) until the auger belt tension has
increased.
3. Retest the auger engagement. Repeat
adjustment as needed until only a small amount
of slack remains in the cable when the lever is
disengaged.
4. Tighten the bottom jam nut to lock in the tension.
Note: You may also tension the auger belt by
adjusting the idler pulley as a secondary option.
If the adjustment does not resolve the problem,
replace the auger belt. See
belt on page 18 .
To adjust the belt tension
1. Remove the belt cover. See
replacement of the belts on page 16 .
2. Loosen the idler pulley nut (A).
690 - 004 - 17.12.2019
B
C
D
To remove the auger
To prepare for
3. Slide the idler pulley closer to the belt to increase
the belt tension. Slide it away from the belt to
decrease the belt tension.
4. Tighten the idler pulley nut (A).
5. To make sure that the belt is declutched fully
when the auger lever is disengaged, have an
assistant stand 10 feet / 3 meters in front of the
product, on the opposite side of the chute. The
assistant observes the rotation of the auger, and
measures the time it takes for the auger to stop
rotating when the lever is released. If the auger
stops rotating after more than 5 seconds, repeat
the adjustment and slide the idler pulley further
from the belt.
B
6. When the auger stops rotating after less than 5
seconds, install the belt cover. See
B
for replacement of the belts on page 16 .
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin
(B).
2. Remove the wheel from the axle (C).
A
B
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
A
B
To prepare
C
19