Husqvarna ST 324 Manual Del Usuario página 18

C
2. Install the discharge chute.
To remove the auger belt
1. Remove the 5/16'' nut and the cable cover (E)
from the frame.
A
E
2. Remove the top 5/16'' bolts and lower ¼'' bolts
(D) from the 2 sides of the frame. Do not discard
the bolts.
3. Loosen but do not remove the lower 5/16'' bolts
(C) on the 2 sides of the frame.
4. Remove the auger belt (B) from the engine pulley
(A).
5. Tilt the rear section down. The front section will
tilt forward at the same time. The bottom bolt is a
hinge between the front and rear sections.
6. Put a wooden block below the hinge point to set
the product in the tilted position.
7. Move the auger brake arm and remove the auger
belt (B) from around the arm.
To install the auger belt
1. Move the auger brake arm (G) and put the auger
belt around and in the groove of the auger pulley
(E).
18
A
B
B
C
D
A
G
F
CAUTION: Make sure that the belt is
not caught between the frame and
auger housing as you put the unit
together.
2. Remove the wooden block from below the
product.
3. Lift the handles to tilt the rear section up. The
front section will tilt back and pivot to attach the
rear section.
4. Make sure that the belt is put in the auger pulley
(E) groove correctly.
5. Install the 5/16'' bolts (C), and tighten (11-16
Nm).
6. Install the ¼'' bolts (D) and tighten (5-8 Nm).
7. Install the auger belt (B) on the engine pulley (A).
Make sure that the belt is put correctly around
the idler pulley and installed correctly in the
engine pulley groove.
8. Install the cable cover (F) and the 5/16" nut on
the frame.
9. Operate all controls to make sure that the auger
belt is installed correctly and that all components
are moving correctly.
To adjust the tension of the cable for
the discharge chute deflector
1. Loosen the jam nuts (B) to adjust the tension of
the cable for the discharge chute adjacent to the
adjuster turnbuckle (A).
B
C
D
E
690 - 004 - 17.12.2019