Filter Replacement (Ss5); Oil Change - Ingersoll Rand SS5L5 Manual Del Propietário

EN
WARNING
Disconnect, lock and tag the main power supply and release air
pressure from the system before performing maintenance��
NOTICE
All compressed air systems contain maintenance parts (e��g��
lubricating oil, filters, separators) which are periodically
replaced�� These used parts may be, or may contain, substances
that are regulated and must be disposed of in accordance with
local, state, and federal laws and regulations��
NOTICE
Take note of the positions and locations of parts during
disassembly to make reassembly easier�� The assembly sequences
and parts illustrated may differ for your particular unit��
NOTICE
Any service operations not explained in this manual should be
performed by an authorized service representative��
ROUTINE MAINTENANCE SCHEDULE
Check lubricant level�� Fill as needed��
Drain receiver tank condensate�� Open
manual drain valve and collect and dispose of
condensate accordingly��
Daily or Before
Check for unusual noise and vibration��
Each Operation
Ensure beltguards and covers are securely in
place��
Ensure area around compressor is free from
rags, tools, debris, and flammable or explosive
materials��
Inspect air filter element(s)�� Clean or replace if
Weekly
necessary��
Inspect for air leaks�� Squirt soapy water
around joints during compressor operation
and watch for bubbles��
Check tightness of screws and bolts�� Tighten
Monthly
as needed��
Inspect drive belts�� Adjust if necessary��
Clean exterior��
/500 " Change petroleum lubricant while crankcase
is warm��
Change synthetic lubricant while crankcase is
warm��
12/2000 "
Replace filter element��
" indicates months/operating hours, whichever occurs first��
EN-10
RELEASED 05/Apr/2018 15:16:08 GMT
MAINTENANCE

FILTER REPLACEMENT (SS5)


1��
2��
��
The air intake holes in the baffle and cover must be staggered
1800�� When reinstalling the assembly at the inlet connection,
ensure the intake hole in the cover is on the bottom to minimize
the entry of foreign matter from the air��

OIL CHANGE


2�� Replace the oil drain plug��
�� Follow the filling procedures in OPERATION section��
Unscrew and remove the wing nut (A) securing the filter housing (B)
to its base (C)��
Remove the filter busing and withdraw the old filter element (D)
Clean the element with a jet of air or vacuum��
Replace the filter element and housing, securing it in place with the
wing nut previously removed��
NOTICE
1�� Remove the oil drain plug (A) and allow the lubricant to drain into
suitable container��
22204945 Rev C