Replacing The Lamp - Sony VPL-HS10 Manual De Instrucciones

Cannot play c The MS SLIDE button has been pressed
while no movie picture files are
contained in the selected folder. Slide
show will not start.
c Image data of a movie picture file is
Cannot play
broken.
Memory Stick c The erasure prevention switch on a
locked "Memory Stick" is set to "LOCK."
Release the lock.
c The "Memory Stick" is broken.
Memory Stick
c Clean the terminal on the "Memory
error
Stick."
Memory Stick c A "Memory Stick" that is not
type error compatible or cannot be used with the
projector has been inserted.
c The"Memory Stick" has not been
Format error
formatted correctly. Format it on this
projector correctly.
c Formatting is not successful.
c The selected folder has not been named
File error
correctly. Reenter the name with less
than 66 characters including "/" by
displaying the "Select Folder" menu.
Read Only c A read-only "Memory Stick" in which
Memory picture files are recorded has been
inserted. You cannot record or delete
the data with a read-only "Memory
Stick."
Caution displays while you are using
the "Memory Stick"
If a picture file has some problem, the following
indicator may appear on the screen. Check the
following to cope with the corresponding situation.
c The image data is the JPEG or MPEG1 format
that is not-compatible.
c There is the thumbnail but it is not DCF-
compatible.
c There is no selected image data.
c There is the image data but the thumbnail is
broken.
c The image data is broken.

Replacing the Lamp

The lamp used for the light source has a certain life.
When the lamp dims, the color balance of the picture
becomes strange, or "Please replace the LAMP."
appears on the screen, the lamp is exhausted. Replace
the lamp with a new one (not supplied).
Use LMP-H180 Projector Lamp as the replacement lamp.
When replacing the lamp after using the
projector
Turn off the projector, then unplug the power cord.
Wait for at least an hour for the lamp to cool.
Caution
The lamp becomes a high temperature after turning off the
projector with the [/1 (on/standby) switch. If you touch the lamp,
you may scald your finger. When you replace the lamp, wait for
at least an hour for the lamp to cool. When removing the lamp
unit, make sure it remains horizontal, then pull straight up. Do not
tilt the lamp unit. If you pull out the lamp unit while tilted and if
the lamp breaks, the pieces may scatter, causing injury.
1 Place a protective sheet (cloth) beneath
the projector. Turn the projector over so
you can see its underside.
Note
Be sure that the projector is stable after turning it over.
53
Replacing the Lamp
GB