Sony VPL-HS10 Manual De Instrucciones página 8

Highly heated and humid
Very dusty and extremely smoky
Do not use the projector under the following
conditions:
Tilting the unit extremely
15˚
Blocking the ventilation holes
Ventilation
Note
Installing the unit at altitudes
When using the projector at an altitude of 1,500 m or
higher, turn on high altitude mode in the INSTALL
SETTING menu. Failing to set this mode when using
the projector at high altitudes could have adverse
effects, such as reducing the reliability of certain
components.
8
Step 1: Installing the Projector
GB
15˚
holes
(exhaust)
Ventilation
holes
(intake)
Using the supplied Cinema Filter
The Cinema Filter is supplied with the projector,
allowing you to receive higher contrast color and
emphasized black color by attaching or removing.
Use it according to preference.
To attach the Cinema Filter
1 Detach the lens hood stopper to remove
the lens hood.
Lens hood stopper
2 Insert the Cinema Filter, aligning its screw
with the thread around the projector's
lens, then turn the Filter clockwise.
3 Attach the lens hood by turning it
counterclockwise until it clicks, and fix the
lens hood with the lens hood stopper.
To remove the Cinema Filter
Perform step 1 above, then turn the Cinema Filter
counterclockwise to remove.
Lens hood