Projecting A Selected Picture When The Power Is Turned On - Startup; Registering A Still Picture As The Startup Picture - Sony VPL-HS10 Manual De Instrucciones

Protecting a movie picture in the
Movie Player
1 Perform steps 1 to 3 in "Playing Movie
Pictures" (1 page 38) to display the Movie
Player on the screen.
2 Press M or m to select "Menu," and press
ENTER.
The movie picture setting menu appears.
Movie picture setting menu
Prev. NEXT
Information
On
Audio Select
Full Screen
L/R
Menu
Protect
Return
Delete
Close
No : 1/1234
Size : 320x240
Appears when a file is protected.
3 Follow steps 3 and 4 in "Protecting an
Important Picture."
File : SJP0001.MPG
Date : 2002/MAY/31 1:08PM
Projecting a Selected
Picture When the Power
Is Turned On — Startup
When the projector is turned on, the specific still
picture stored in the projector is projected
automatically for about one minute, even if no signal
is input. You can change this still picture to the one
you prefer.
Registering a Still Picture
as the Startup Picture
When you want to use a picture stored in your
"Memory Stick" as the startup picture, register the
picture in the "Memory Stick."
Tip
You cannot register a movie file as the startup picture.
LIGHT INPUT
DYNAMIC STANDARD CINEMA
PICTURE MODE
USER 1 USER 2 USER 3
ENTER
APA MS SLIDE MENU
WIDE MODE LENS RESET
1
Display the Memory Stick
Home. (1 page 33)
2
Press M, m, < or , to select
the picture you want to use as
the startup picture, and press
ENTER.
Projecting a Selected Picture When the Power Is Turned On — Startup
2-4
43
GB