Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Principle
Due to the oscillating drive the application tool/accessory
swings up to 21000 times per minute for 2.8°. This allows for
precise work in narrow spaces.
Work with low and uniform application
p r e s s u r e , o t h e r w i s e , t h e w o r k i n g
performance will decline and the application
tool can become blocked.
While working, move the machine back and
forth, so that the application tool does not
heat up excessively and become blocked.
Sawing
l
Use undamaged faultless saw blades only.
Deformed, blunt saw blades or saw blades that are
otherwise damaged can break.
l
When sawing light building materials, observe the
statutory provisions and the recommendations of
the material suppliers.
l
Plunge cuts may only be applied to soft materials,
such as wood, gypsum plaster boards, etc.!
Before sawing with HSS saw blades in wood, particle
board, building materials, etc., check these for foreign
objects such as nails, screws, or similar. If required, remove
foreign objects or use BIM saw blades.
Sanding
The removal rate and the sanding pattern are primarily
determined by the choice of sanding sheet, the preset
oscillation rate and the applied pressure.
Only flawless sanding sheets achieve good sanding
capacity and extend the service life of the machine.
Pay attention to apply uniform sanding pressure; this
increases the working life of the sanding sheets.
Intensifiying the sanding pressure does not lead to an
increase of the sanding capacity, but to increased wear of
the machine and the sanding sheet.
For precise on-the-spot sanding of edges, corners and hard
to reach areas, it is also possible to work only with the tip or
an edge of the sanding plate.
When selectively sanding on the spot, the sanding sheet
can heat up considerably. Reduce the orbital stroke rate
and allow the sanding sheet to cool down regularly.
A sanding sheet that has been used for metal should not be
used for other materials.
For sanding, always connect dust extraction.
ENGLISH
14
Scraping
For scraping, select a high oscillation rate.
Work on a soft surface (e.g. wood) at a flat ange, and apply
only light pressure. Otherwise the scraper can cut into the
surface.
5. Maintenance and Service
Maintenance and Cleaning
l
Before any work on the machine itself, pull the
mains plug.
l
For safe and proper working, always keep the
machine and ventilation slots clean.
Clean Riff application tools (accessory) regularly with a wire
brush.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for Stayer.
After-sales Service and Customer Assistance
Our after-sales service responds to your questions
concerning maintenance and repair of your product as well
as spare parts.
Our customer service representatives can answer your
questions concerning possible applications and adjustment
of products and accessories.
Stayer Ibérica S.A.
Area Empresarial de Andalucía - Sector 1
Calle Sierra de Cazorla 7
28320 Pinto, Madrid (Spain)
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline 2002/96/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right,
power tools that are no longer usable must be
collected separately and disposed of in an
environmentally correct manner.
14
Publicidad
Tabla de contenido
