Changing The Tool - stayer MULTI TOOL 250 Manual De Instrucciones

Vibration total values (triax vector sum) determined
according to EN 60745:
Sanding: Vibration emission value
2
a =2 m/s , uncertainty K=1.4 m/s
h
Cutting with plunge cut saw blade: Vibration
emission value
2
a =10 m/s , uncertainty K=1.5 m/s
h
Cutting with segmential saw blade: Vibration emission
value
2
a =6.5 m/s , uncertainty K=1.5 m/s
h
Scraping: Vibration emission value
2
a =4.5 m/s , uncertainty K=1.5 m/s .
h
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool
with another.It may be used for a preliminary assessment of
exposure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for
different applications, with different accessories or poorly
maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should
also take into account the times when the tool is switched
off or when it is running but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and
the accessories, keep the hands warm, organisation of
work patterns.
3. Assembly

Changing the Tool

l
Before any work on the machine itself, pull the
mains plug.
l
Wear protective gloves when changing application
tools/accessories. Contact with the application
tool/accessoriy can lead to injuries.
ENGLISH
2
2
2
2
12
Selecting the Application Tool/Accessory
Accessory
HSS wood
segment saw
blade
BIM segment saw
blade
HSS plunge cut
saw blades, wood
BIM plunge cut
saw blades, metal
BIM plunge cut
saw blade, wood
and metal
Base plate for
sanding, series
Delta 93 mm.
Mounting/Replacing the Application Tool/ Accessory
If required, remove an already mounted application
tool/accessory.
For removing the application tool/accessory, loosen the
screw 7 with the Allen key 8 and remove the application
tool/accessory.
Mount the requested application tool/accessory (e.g.
plunge cut saw blade 6) in such a manner on the tool holder
4 that the offset faces downward (see illustration on the
graphics page; marking on the application tool/accessory is
readable from above).
Turn the application tool/accessory to a position favourable
for the respective job, and allow it to engage into the cams of
the tool holder 4. 12 different positions are possible, each
offset by 30°.
Fasten the application tool/accessory with bolt 7. Tighten
the bolt with Allen key 8 until the spring washer of the bolt
faces flush against the application tool/accessory.
l
Check the tight seating of the application
tool/accessory. Incorrect or not securely fastened
application tools/accessories can come loose during
operation and pose a hazard.
12
Material
Wooden materials,
plastic
Wooden materials,
plastic.
Wooden materials,
plastic, gypsum and
other soft materials
Metal (e.g.
unhardened nails,
screws, smaller
profiles), non-
ferrous metals
Wood, metal, non-
ferrous metals
Depends on
sanding sheet