KOBE Brillia Serie Instrucciones De Instalación Y Manual De Operación página 12

Ductwork Installation
10. Use steel pipe to connect the exhaust on the hood
to the ductwork. Use duct tape to make all joints
secure and air tight.
Install Accessories
11. Install the Oil Tunnel {I} into recess support near
rear of hood. Refer to Figure 7.
12. Install Baffle Filters {D} and Stainless Steel
Spacers {E}. Angle baffle filter toward back of
hood. Push the baffle filter up until almost
level. Slide forward into recess behind the front
of hood. Lower baffle filter.
it fits into resting position. Refer to Figure 8.
13. For Stainless Steel Spacer, follow above steps.
Final Installation
14. Turn power ON in control panel. Check all lights
and fan operation.
15. Make sure to leave this manual for the
homeowner.
Figure 7
Figure 8
Slide back until
10