Repairing; Troubleshooting - Stihl RMA 2 RV Manual De Instrucciones

18 Repairing

► Remove the blade.
► Sharpen the blade. Observe the sharpening
angle and cool the blade,
Bluing of the blade during sharpening is not
permitted.
► Attach the blade.
► If anything is unclear: consult a STIHL special‐
ist dealer.
18 Repairing
18.1 Repairing the Mower and Bat‐
tery
The mower, blade and battery cannot be
repaired by the user.

19 Troubleshooting

19.1 Remedying Lawn Mower or Battery Faults
Fault LEDs on the
battery
The lawn mower 1 LED flashes
does not start green.
when switched
on.
1 LED illumina‐
tes red.
3 LEDs flash
red.
3 LEDs illumi‐
nate red.
4 LEDs flash
red.
0478-131-9950-B
20.2.
Cause
The battery charge
state is too low.
The battery is too
warm or too cold.
There is a fault in the
lawn mower.
The lawn mower is
too warm.
There is a fault in the
battery.
The electrical connec‐
tion between the lawn
mower and battery
has been interrupted.
The lawn mower or
battery are damp.
The resistance at the
blade is too great.
► If the mower or the blade is damaged: Do not
use your mower and contact your STIHL serv‐
icing dealer for assistance.
► If the battery has a malfunction or is damaged:
Replace the battery.
► If safety labels are illegible or damaged: Have
the labels replaced by a STIHL servicing
dealer.
Remedy
► Charge the battery.
► Pull out the activation key.
► Remove the battery.
► Allow the battery to cool down or warm
up.
► Pull out the activation key.
► Remove the battery.
► Clean the electric contacts in the battery
compartment.
► Fit the battery.
► Switch the lawn mower on.
► If 3 LEDs still flash red: do not use the
lawn mower and consult a STIHL spe‐
cialist dealer.
► Pull out the activation key.
► Remove the battery.
► Allow the lawn mower to cool down.
► Remove the battery and fit it again.
► Switch the lawn mower on.
► If 4 LEDs still flash red: do not use the
battery and consult a STIHL specialist
dealer.
► Pull out the activation key.
► Remove the battery.
► Clean the electric contacts in the battery
compartment.
► Insert the activation key.
► Fit the battery.
► Pull out the activation key.
► Remove the battery.
► Clean the lawn mower.
► Allow the lawn mower or battery to dry.
► Set a higher cutting height.
English
39