EN
INSTRUCTIONS FOR USE
Fig. 1 : In order to avoid unnecessary strain on the awning, we suggest
to take out the legs at about 1 m from the opening.
Fig. 2 : Unscrew the leg knob to slide the leg out of its seat.
Fig. 3 : Grasp the leg near its hinge-joint and pull it in a horizontal
direction.
Fig. 4 : Lower the leg as shown in the figure.
Fig. 5 : After unrolling the awning completely, adjust the legs at the chosen
height.
Fig. 6 :To avoid that the awning is lifted up by an unexpected gust of wind,
it is necessary to secure the legs to the ground with the provided
hooks. For safety's sake, we strongly advise you also use some
storm cords in the upper part of each support leg or anchor the
awning with the Fiamma Tie-Down Kit strap.
Fig. 7 : If you want to fasten the support legs to the vehicle, put the
terminals into the wall brackets. The brackets can be fixed only in
reinforced points.
Fig. 8 : We remind you that the awning is a sun protection, so please roll
up your awning in case of rain, wind or snow. Otherwise, please
take the following precautions: lower one side of your awning, so
that water can flow away and place the tension rafter as
shown in the figure (not included for all awning lengths).
Fig. 9 : Make sure that the awning perfectly rolls up.
A damaged fabric does not allow the awning to perfectly roll up.
Never use the awning with a damaged canopy.
Wash the canopy with light cleaning detergent and not with chimical
weapon.
In case of problems, please contact the dealer closest to you or
the address in the last page.
ATTENTION
We remind you that the awning is designed to protect
from the sun, and not from rain, wind or snow.
In these cases, we recommend to roll it up!
®
8
®