Intended Use; Technical Data - IKRA IEVL 1532 Instrucciones De Manejo

4. INTENDED USE

Proper use
Depending on the fitted cutting device this product it is either intended for scarifying and removing thatch from lawns
or for raking in domestic and hobby gardens.
• When used as a scarifier, this product works by scratching through and between the grass with specially adapted
prongs that collect and remove any unwanted parts from the lawn whilst leaving the grass blades intact. At the same
time the product scarifies the ground resulting in a better airing.
• When used as a raker, the fine needles will scratch the surface of the lawn while simultaneously picking light debris
for better oxygen absorption, airing and draining.
Improper use
The appliance must not be used in permanent operation and not in industrial environments.
Residual risks
Even if you are operating this product in accordance with all the safety requirements, potential risks of injury and
damage remain. The following dangers can arise in connection with the structure and design of this product:
1. Health defects resulting from vibration emission if the product is being used over long periods of time or not
adequately managed and properly maintained.
2. Injuries and damage to property due to broken application tools or the sudden impact of hidden objects during use.
3. Danger of injury and property damage caused by flying objects.
5. TECHNICAL DATA: Electrical scarifier & raker IEVL 1532
Supply voltage
Power
No-load speed n
0
Weight
Grass bag
Working width
Height adjustment (scarifier)
Sound pressure level
(EN 50636-2-92:2014)
sound power level
Measured
Guaranteed sound power level
Vibration on the handle
Transmission
Insulation class
Safety class
Emissions
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks
Please wear ear protectors!
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine
Directive: the noise pressure level at the place of work can exceed 80 dB(A). In such cases the operator will
require noise protection (e.g. wearing of ear protectors).
Please do also consider any local regulations concerning noise protection!
GB | Operating Instructions
(2000/14/EU)
(2000/14/EU)
(EN 50636-2-92:2014)
V~/Hz 230-240 / 50
W 1500
min -1 3000
kg 8,6
L 30
mm 320
mm -12, -8, -4, +4
dB(A) 84,5
[K=3,0 dB (A)]
dB(A) 97,3
[K=1,05 dB (A)]
dB(A) 98
m/s 2 4,246
[K=1,5 m/s
Drive belt
II
IPX4
GB-7
2
]